Amana GCIS Specifikace stáhnout pdf (Strana 8)

Even though a return air filter is not supplied with this fur-

nace, the return air must be filtered. The installer must sup-

ply filters at the time of installation. Become familiar with

filter location and procedures for removing, cleaning and

replacing them. If needing help, contact the installer of the

furnace or another qualified servicer.

If filter replacement becomes necessary, it must be replaced

with a filter of the same type and size that complies with

UL900 or CAN/ULC-S111 standards.

See the Specification Sheet for filter sizes.

WARNING

PERSONAL INJURY HAZARD

To avoid death or personal injury due to elec-

trical shock, disconnect the electrical power

before removing filters or performing any

maintenance.

Filters must be inspected, cleaned or changed every two

months or as required. It is the owner's responsibility to keep

air filters clean. NOTE: Dirty filters are the most common

cause of inadequate heating or cooling performance.

Upflow Filters (Not Included With Furnace)

To remove the external upflow filter from the external filter

rack, disconnect electrical power to the furnace and follow

the directions provided with the external filter rack kit.

NOTE: If using Media Air Cleaner MAC1 or Electronic Air

Cleaner EAC5, follow the directions that came with the air

cleaner for proper filter removal, cleaning, and replacement

procedures.

Remove the two front panels (louvered panel first). Using a

vacuum cleaner, clean out the blower area, external filter

rack area, and the adjacent area of the return air duct.

Some installations will have throwaway filters. If dirty, these

filters must be thrown away and replaced with two new simi-

lar size throwaway filters. Other installations will have per-

manent filters. If dirty but not torn, these filters must be

cleaned as follows:

Wash, rinse, and dry a permanent filter. Both sides of a metal

filter should be sprayed with a dust adhesive as recom-

mended on the adhesive container. Spray adhesives for use

with permanent metal filters can be found at some hardware

stores.

If badly torn or uncleanable, these filters must be replaced

with permanent filters of the same type and size.

To reinstall filter follow instructions included with extenal fil-

ter rack kit. BE SURE AIRFLOW DIRECTION ARROW

POINTS TOWARDS THE BLOWER.

When the filter is located in the bottom of the furnace on a

bottom return system the filter is held in place by a wire filter

retainer (Figure 6). To change and clean the filter, push back

and up on the wire filter retainer to release it from under the

front lip of the basepan. Slide the filter out and follow clean-

ing or replacement instructions above. Replace filter oppo-

site of removal.

Figure 6

Wire Filter Retainer

Counterflow Filters (Not Included With Furnace)

The furnace-mounted filter rack includes a rack mounted on

the top of the furnace. Two filters fit into the rack and rest

against the sides of the return air plenum, forming a “V” above

the furnace (Figure 7).

Figure 7

Counterflow Furnace Mounted Filter Rack

Remember dirty filters are the most common cause of inad-

equate heating or cooling performance.

NOTE: If using Media Air Cleaner MAC1 or Electronic Air

Cleaner EAC5, follow the directions that came with the air

cleaner for proper filter removal, cleaning, and replacement

procedures.

The filters should be inspected and cleaned or changed ev-

ery two months or as required. In some installations, the

1 2 3 4 5 6 7 8 9 10 11

Komentáře k této Příručce

Žádné komentáře

Amana GCIS Specifikace Strana 8

Komentáře k této Příručce

Související produkty a manuály pro Krby Amana GCIS